Darren's Agera Build

Build forum for the fully 3D-printed Koenigsegg Agera RS in scale 1/10
Darren
Posts: 3
Joined: Thu Jun 13, 2019 12:17 pm

Darren's Agera Build

Postby Darren » Wed Jul 10, 2019 4:59 pm

So I came across this build on one of the open Rc groups I belong to and once I saw the car fell in love with it and knew I had to print and paint the car ....
I thought I would run through my progress so far .
I am printing all body parts in White Formfortura easyfill PLA
My printer is a FLSUN QQ-S Delta printer
I have printed all parts at 0.1 layer height ,most parts 20% infill and some 100% infill, speed 45/mms

Started on the body work
Attachments
20190622_122107.jpg
Doors in two parts per side
20190622_122107.jpg (2.72 MiB) Viewed 5350 times
20190622_122406.jpg
Vents Hood both
20190622_122406.jpg (4.08 MiB) Viewed 5350 times
20190622_122245.jpg
Front flaps both
20190622_122245.jpg (2.99 MiB) Viewed 5350 times
20190622_122130.jpg
Front aft
20190622_122130.jpg (3.05 MiB) Viewed 5350 times
20190622_122158.jpg
Bottom Plate
20190622_122158.jpg (2.54 MiB) Viewed 5350 times
20190622_122143.jpg
Front forward
20190622_122143.jpg (2.92 MiB) Viewed 5350 times
20190616_132320.jpg
Hood arm connections
20190616_132320.jpg (2.61 MiB) Viewed 5350 times
20190616_132226.jpg
Hood back side two parts glued together
20190616_132226.jpg (2.35 MiB) Viewed 5350 times
20190616_132128.jpg
Hood front side two parts glued together
20190616_132128.jpg (2.75 MiB) Viewed 5350 times

Who is online

Users browsing this forum: No registered users and 1 guest